I received a Baldor metal grinder with 10-inch wheels, on its own pedestal floor stand, discarded from a school metal shop program. Several owners before me did not know what to do with it, mainly because the motor is wired for three-phase industrial power which is not found in U.S. residential homes. My job was to fix it up and get it working.

There were two major tasks to the restoration: cleaning/repainting, and making the three-phase motor work.

Cleaning and Painting

I started the cleaning process by removing all attachments that I could, including the wheel shroud side covers, the wheels themselves, and all electrical boxes and covers. I remove all of the old flaking paint and minor rust spots using a wire wheel brush on the electric drill. Some of the paint was still good, but much of it was stripped down to the bare metal. I could not remove like the riveted-on motor label and didn't want to paint like the wheel axles, so I covered them with masking tape.

I spray painted the entire grinder and all the separate parts with primer for a good base coat. I followed it with a few coats of grey paint.

I cleaned up the hardware to make it look a little nicer. I filed and sanded the heads of the screws and bolts while spinning them in the drill press. I buffed all of them with a cloth wheel, which made them nice and shiny. I finished it with some clear spray varnish.

I reassembled all the pieces, back in the order they came off.

Electrical

Final assembly

The last step was to add some labels. I made labels for the various boxes and buttons on the machine, and also for the power cord and outlets. I drew them using Inkscape and printed them with my inkjet printer on glossy photo paper. I used rubber cement to glue them in place, and covered them with clear packing tape.

The final results are very satisfying, and I think this is my best restoration project yet.